What should be paid attention to in the assembly of animal husbandry fan

Because there are many problems in the use of animal husbandry fans, there will be many problems in the use of users. If the fan cannot be installed according to the standard, the use of the fan will not be standardized. Therefore, the installation specification of fan is more important. What specifications should be paid attention to when assembling?

1. It is important in the debugging process, and the number of people participating in the debugging of the cooling fan is not less than 2. One person controls the power supply of the fan, and the other person pays attention to the operation of the fan. If found abnormal, should inform the control power supply personnel, stop the detailed inspection. Before confirming no abnormality, the motor power required by the fan refers to the higher power required by the fan under relative conditions when the air inlet is fully open.

2. Check whether the wiring mode is the same as the wiring diagram. Check whether the working voltage of the fan power supply meets the requirements, whether the power supply is in phase or in phase, and whether the capacity of electrical components meets the requirements. When the animal husbandry fan reaches the normal speed, measure whether the input current of the fan is normal, and the working current of the fan shall not exceed its rated current. If the operating current is greater than the rated current, check whether the power supply voltage is normal. The use manual of self-assembled fan is not complete, but in any case, even if the manual is not complete, we should also have a more in-depth understanding of the use of fan, each part has detailed use instructions, users should master well.

3. Close the valve on the inlet and outlet pipe of the fan during the animal husbandry fan test. After the work is finished, open the valve gradually until the required working conditions are reached. Pay attention to whether the working current of the fan is greater than the rated current. This is also a good way to use fans, but the debugging method is relatively different for different types of fans assembled by users. Users can focus a little on their debugging and assembly.+